CAUTION: Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION 1. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. NOTE 2. Remove the heater and cooling unit assembly. Heater and Cooling Unit > REMOVAL 3. Pull out the heater core. Heater Core > REMOVAL 4. Remove the screws, and remove the duct - foot assist. 5. Remove the heater case lower. (1) Remove the clip, and remove the connector. (2) Remove the packing. (3) Remove the screw and lock, then remove the heater case lower. 6. Remove the evaporator. 7. Remove the expansion valve - cooling. Expansion Valve > REMOVAL 8. Remove the evaporator sensor. Evaporator Sensor > REMOVAL |
Installation
1. REAR DOOR PANEL1. Put a wooden block and the like on a jack and place the panel assembly - rear door on it.2. Adjust the height by the jack, and temporarily install the panel assembly - rear door to the upper hinge - rear door and the lower hinge - rear door.NOTE:• When installing the panel ...