1. GLOVE BOX LIGHT 1. Disconnect the ground terminal from battery sensor. NOTE 2. Remove the pocket assembly. Glove Box > REMOVAL 3. Remove the light - pocket cover. CAUTION: When using a flat tip screwdriver, apply protective tape or cloth and be careful not to cause damage. (1) Release the claws. (2) Disconnect the connector, and remove the light - pocket cover. 4. Release the claws, and remove the light - pocket. 2. POCKET LIGHT 1. Disconnect the ground terminal from battery sensor. NOTE 2. Remove the heater control assembly. Control Panel > REMOVAL 3. Remove the light - pocket. CAUTION: When using a flat tip screwdriver, apply protective tape or cloth and be careful not to cause damage. (1) Disconnect the connector. (2) Release the claws, and remove the light - pocket. 3. DOOR POCKET LIGHT 1. Disconnect the ground terminal from battery sensor. NOTE 2. Remove the trim panel - front door. Door Trim > REMOVAL 3. Release the claws, and remove the light - door pocket. CAUTION: When using a flat tip screwdriver, apply protective tape or cloth and be careful not to cause damage. |
Brake system
Two separate circuits
Your vehicle has a dual circuit brake
system. Each circuit works diagonally
across the vehicle. If one circuit of the
brake system should fail, the other half of
the system still works. If one circuit fails,
the brake pedal will go down much closer
to the floor than usua ...