Subaru Legacy BN/BS (2015-2019) Service Manual: Removal
1. Disconnect the ground terminal from battery sensor. NOTE 2. Remove the trim panel - front pillar UPR. Upper Inner Trim > REMOVAL 3. Release the clips and claws, then detach the grille speaker side. Front Speaker > REMOVAL 4. Remove the sensor - automatic light. (1) Release the claws of the duct - front defroster. CAUTION: • Secure minimum space for performing the operation. Do not remove the duct - front defroster. If the duct - front defroster is removed, it cannot be reinstalled unless the instrument panel is removed. • Be careful not to damage the sensor and interior trim.
(2) Release the claws, and then pull out the sensor - automatic light from the duct - front defroster. (3) Disconnect the connector and remove the sensor - automatic light.
|
Inspection
1. Connect the connector.2. Turn the ignition switch to ON, and set the lighting switch to the AUTO position.3. Measure the voltage between connector terminals.Preparation tool:Circuit testerTerminal ...
Other materials:
Dtc p0137 o2 sensor circuit low voltage bank 1 sensor 2
DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.WIRING DIAGRAM:• Engine Electrical System ENGINE T ...
