Subaru Legacy BN/BS (2015-2019) Service Manual: Removal
1. SEDAN MODEL 1. Disconnect the ground terminal from battery sensor. NOTE 2. Remove the trunk trim panel - side. Trunk Room Trim > REMOVAL 3. Remove the light assembly - rear combination. (1) Remove the harness clip and connector. (2) Release the nuts and clips, then remove the light assembly - rear combination. CAUTION: Be careful not to damage the clips.
2. OUTBACK MODEL 1. Disconnect the ground terminal from battery sensor. NOTE 2. Remove the light assembly - rear combination. (1) Remove the clips and detach the rear combination light covers. (2) Remove the bolt and release the clip. (3) Disconnect the connector and remove the light assembly - rear combination. CAUTION: Be careful not to damage the clips.
|
Assembly
CAUTION:Use a dry clean cloth so that no grease or water adheres to the glass portion of the bulb.1. TURN SIGNAL LIGHT BULB1. Install the turn signal light bulb.2. Install the bulb socket.2. SIDE MARK ...
Other materials:
Steering switches for audio
Some parts of the audio/visual system can
be adjusted using the switches on the
steering wheel.
1) + − switch
2) switch
3) Mute/Enter switch
4) Back switch
5) List switch
6) Source switch
+/− switch
Mode
Operation
Function
Except list screen
...
