CAUTION: Always remove the sensor assembly - headlight beam leveler before removing any parts related to the suspension. 1. Disconnect the ground terminal from battery sensor. NOTE 2. Lift up the vehicle. 3. Remove the rear wheel on the left side. 4. Remove the sensor assembly - headlight beam leveler. CAUTION: Do not disassemble the sensor and lever. (1) Disconnect the connector. (2) Remove the nuts, and remove the sensor assembly - headlight beam leveler. |
Installation
1. Clean the mating surface of oil pump chain cover and converter case.2. Using the ST, install the oil seal.NOTE:• Use a new oil seal.• Apply CVTF to the oil seal lip and press-fitting surface.ST 499755602PRESS SNAP RING3. Install the drive sprocket.4. Install the snap ring so that i ...