NOTE: Do not remove the trunk room light if removing the bulb only. 1. Disconnect the ground terminal from battery sensor. NOTE 2. Remove the light assembly - trunk room. (1) Release the claws. (2) Disconnect the connector and remove the light assembly - trunk room. 3. Release the claws to open the bulb cover, then remove the bulb. CAUTION: • Use a dry clean cloth so that no grease or water adheres to the glass portion of the bulb. • When using a flat tip screwdriver, apply protective tape or cloth and be careful not to cause damage. |
Inspection
1. Check the resistance between connector terminals.Preparation tool:Circuit tester• Changeover switch RHTerminal No.Inspection conditionsStandard — OFF1 M- or more1 — 129 — 7UPLess than 1 -1 — 912 — 7DOWNLess than 1 -1 — 1112 — 7LEFTLess than 1 -1 — 1211 — 7RIGHTLess than 1 ...