Subaru Legacy BN/BS (2015-2019) Service Manual: Removal
1. Remove the engine from vehicle. Engine Assembly > REMOVAL 2. Remove the crank pulley. Crank Pulley > REMOVAL 3. Remove the chain cover. Chain Cover > REMOVAL 4. Remove the timing chain assembly. Timing Chain Assembly > REMOVAL 5. Remove the cam sprocket. Cam Sprocket > REMOVAL 6. Remove the crank sprocket. Crank Sprocket > REMOVAL 7. Remove the exhaust oil flow control solenoid valve. Oil Flow Control Solenoid Valve > REMOVAL 8. Remove the camshaft position sensor. Camshaft Position Sensor > REMOVAL 9. Loosen the rocker cover bolts in the order indicated in the figure, and remove the rocker cover. • LH side
• RH side
10. Loosen the camshaft cap bolts equally, a little at a time in numerical sequence, as shown in the figure.
11. Remove the camshaft caps and camshaft (RH). NOTE: Arrange camshaft caps in order so that they can be installed in their original positions. 12. Similarly, remove the camshaft (LH) and related parts. |
Camshaft
...
Inspection
1. Measure the bend, and repair or replace if necessary.Camshaft bend limit:0.020 mm (0.00079 in)2. Check the journal for damage and wear. Replace if faulty.3. Check the cutout portion used for camsha ...
Other materials:
Dtc c1531 bls off stuck
DTC DETECTING CONDITION:A fault is detected if stop light switch signal is OFF for a predetermined time or more with the pressure signal of the pressure sensor high.TROUBLE SYMPTOM:• VDC does not operate.• Hill hold does not function.• EyeSight does not operate. (Models with EyeSig ...
