Subaru Legacy BN/BS (2015-2019) Service Manual: Removal

Subaru Legacy BN/BS (2015-2019) Service Manual / Power rear gate system / Power rear gate drive unit / Removal

1. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. NOTE

2. Remove the rod - power rear gate. Power Rear Gate Rod > REMOVAL

3. Remove the trim panel - rear apron LH and trim panel - rear quarter trim UPR rear LH. Rear Quarter Trim > REMOVAL

4. Remove the power rear gate drive unit (PRG D/U).

(1) Remove the harness clip, and disconnect the connector.

NOTE:

Pull the slide lock in the arrowed direction, and disconnect the PRG CM connector by pressing in the lock.

(2) Remove the bolts, and then remove the power rear gate drive unit (PRG D/U).

Installation

1. Install the power rear gate drive unit (PRG D/U).Tightening torque:25 N·m (2.5 kgf-m, 18.4 ft-lb)2. Install the trim panel - rear apron LH and trim panel - rear quarter trim UPR rear LH.3. I ...

Other materials:

Charge
WARNING:• Do not bring an open flame close to the battery when working.CAUTION:• Prior to charging, corroded terminals should be cleaned with a brush and common caustic soda solution.• Be careful while charging the battery because it produces flammable gasses.• Observe instru ...