Subaru Legacy BN/BS (2015-2019) Service Manual: Removal

Subaru Legacy BN/BS (2015-2019) Service Manual / Power rear gate system / Power rear gate driver’s switch / Removal

1. Disconnect the ground terminal from battery sensor. NOTE

2. Remove the cover assembly - instrument panel LWR driver. Instrument Panel Lower Cover > REMOVAL

3. Release the claws, and then remove the power rear gate driver’s switch (a).

Power rear gate driver’s switch

...

Inspection

1. Measure the resistance between connector terminals.Preparation tool:Circuit testerTerminal No.Inspection conditionsStandard1 — 4Switch OFF1 M- or moreSwitch ONLess than 1 -2. Apply battery voltag ...

Other materials:

Dtc b1763 occupant detection module calibration checksum
DTC DETECTING CONDITION:• Malfunction is detected on vehicle delivery or at memory writing for «Rezero».• Occupant detection control module is faulty.STEPCHECKYESNO1.CHECK DTC.Read the DTC of the occupant detection system. Read Diagnostic Trouble Code (DTC)Are DTCs other than DTC B176 ...