Subaru Legacy BN/BS (2015-2019) Service Manual: Removal

Subaru Legacy BN/BS (2015-2019) Service Manual / Power rear gate system / Power rear gate inner switch / Removal

1. Disconnect the ground terminal from battery sensor. NOTE

2. Remove the power rear gate inner switch.

(1) Release the claws and pull out the power rear gate inner switch rearward.

NOTE:

Insert a flat tip screwdriver wrapped with protective tape into the slit on the left.

(2) Disconnect the connector and remove the power rear gate inner switch.

1. Measure the resistance between connector terminals.Preparation tool:Circuit testerTerminal No.Inspection conditionsStandard1 — 2Switch OFF1 M- or moreSwitch ONLess than 1 -2. Replace the power re ...

Other materials:

Dtc b16a8 short in front sub sensor lh (to +b)
DIAGNOSIS START CONDITION:Ignition voltage is 10 V to 16 V.DTC DETECTING CONDITION:Shorted between front sub sensor LH circuit and power supply circuitWIRING DIAGRAM:NOTE:For the coupling connector, refer to “WIRING SYSTEM”.Airbag system Airbag System > WIRING DIAGRAMSTEPCHECKYESNO1.CHE ...