Subaru Legacy BN/BS (2015-2019) Service Manual: Removal
NOTE: • The button - opener rear gate is integrated with the rear lock button. • Open the panel - rear gate before disconnecting the ground terminal from battery sensor. 1. Disconnect the ground terminal from battery sensor. NOTE 2. Remove the trim panel - rear gate. Rear Gate Trim > REMOVAL 3. Remove the garnish assembly - rear gate. Rear Gate Garnish > REMOVAL 4. Remove the button - opener rear gate. (1) Remove the garnish switch bracket from the garnish assembly - rear gate. (2) While pushing the locks at both ends of the button - opener rear gate with a flat tip screwdriver, remove the button - opener rear gate together with the rear lock button.
|
Inspection
Unit inspectionPreparation tool:Circuit tester1. Check the resistance between connector terminals.Terminal No.Inspection conditionsStandard1 — 2OPENLess than 5 -CLOSE1 M- or more2. If the inspection ...
Other materials:
Assembly
1. Apply grease to the shaft sliding surfaces of the internal gear assembly.Grease:Multemp #6129 or equivalent2. Assemble the shaft to the internal gear assembly.3. Assemble the overrunning clutch as follows:(1) Apply grease to the spline portion of the shaft.Grease:Multemp #6129 or equivalent(2) In ...
