1. Raise the glass assembly - rear door to the top position. 2. Disconnect the ground terminal from battery sensor. NOTE 3. Remove the trim panel - rear door. Door Trim > REMOVAL 4. Remove the sealing cover - rear door. Rear Sealing Cover > REMOVAL 5. Remove the screws and move downward the latch & actuator assembly - rear. 6. Remove the cover - handle rear outer. Preparation tool: TORX® T30 (1) Loosen the TORX® bolt. (2) Release the claws, and then remove the cover - handle rear outer. 7. Remove the holder of the frame assembly - rear door outer. 8. Remove the handle - door outer. CAUTION: Do not apply excessive force to remove the handle - door outer from the frame assembly - rear door. (1) Pull the handle - door outer rearward to release engagement of the frame assembly - rear door outer. (2) Pull the handle - door outer towards yourself to remove the handle - door outer. 9. Remove the frame assembly - rear door outer. Preparation tool: TORX® T30 (1) Remove the spacer - door handle outer. (2) Loosen the TORX® bolt and remove the frame assembly - rear door outer. |
Dtc p2096 post catalyst fuel trim system too lean bank 1
DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.WIRING DIAGRAM:• Engine Electrical System ENGINE T ...