Subaru Legacy BN/BS (2015-2019) Service Manual: Removal

Subaru Legacy BN/BS (2015-2019) Service Manual / Vehicle dynamics control (vdc) / Front abs wheel speed sensor / Removal

1. Disconnect the ground terminal from battery sensor. NOTE

2. Lift up the vehicle, and then remove the front wheels.

3. Remove the front ABS wheel speed sensor.

CAUTION:

• Be careful not to damage the sensor.

• Do not apply excessive force to the sensor harness.

• Leave the sensor harness clamp on the vehicle side.

(1) Disconnect the connector of the front ABS wheel speed sensor in the engine compartment.

(2) Remove each harness clip and grommet.

(3) Remove the front ABS wheel speed sensor from the housing assembly - front axle.

Inspection

1. CHECK WITH SUBARU SELECT MONITOR1. Connect the Subaru Select Monitor to data link connector.NOTE:For detailed operation procedures, refer to “Application help”.(1) On «Start» display, ...

Other materials:

Installation
CAUTION:• Be sure to use a new flange nut and self-locking nut.• Always tighten the bushing in the state where the vehicle is at curb weight and the wheels are in full contact with the ground.1. Install the nut of shock mount - rear.Tightening torque:30 N·m (3.1 kgf-m, 22.1 ft-lb) ...