CAUTION: • If the steering wheel and steering angle sensor are removed, perform “VSC(VDC) Centering Mode” of the VDC. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) > ADJUSTMENT • Before handling the airbag system components, always refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION • Always use the steering wheel puller for removal to avoid deforming the steering wheel. • If the steering wheel has been removed, make sure that the steering roll connector is not turned from the original position. 1. Position the front wheels straight ahead. 2. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. NOTE 3. Remove the driver’s airbag module. Driver’s Airbag Module > REMOVAL 4. Remove the steering wheel. Steering Wheel > REMOVAL 5. Remove the cover assembly - column. (1) Remove the clips, and remove the cover - column (a). (2) Remove the screws. (3) Release the claws, and remove the cover assembly - column UPR (b) and the cover assembly - column LWR (c). 6. Remove the steering roll connector. CAUTION: Make sure that the steering roll connector is not turned from the original position. (1) Disconnect the connector under the steering roll connector. (2) Release the claws and remove the steering roll connector. 7. Remove the steering angle sensor. (1) Release the claws and remove the steering angle sensor (b) from the steering roll connector (a). |
Preparation tool
1. SPECIAL TOOLILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS18460AA050CHECK BOARDUsed for inspecting the radiator fan system.73099SG000SPECIAL TOOL CONDENSERUsed for removing and installing the radiator. — (Newly adopted tool)SUBARU SELECT MONITOR 4Used for setting of each function and troubleshooting ...