Subaru Legacy BN/BS (2015-2019) Service Manual: Removal

Subaru Legacy BN/BS (2015-2019) Service Manual / Intake (induction)(h6do) / Air cleaner element / Removal

1. Disconnect the ground terminal from battery sensor. NOTE

2. Remove the air intake duct. Air Intake Duct > REMOVAL

3. Disconnect the connector (A) from the mass air flow and intake air temperature sensor, and remove the clip (B) from the air cleaner case (rear).

4. Loosen the clamp (A) securing the air intake boot to the air cleaner case (rear), and then remove the clip (B) from the air cleaner case (front).

5. Remove the air cleaner case (rear) and air cleaner element.

Inspection

1. Check that the air cleaner element has no deformation, cracks or other damages.2. Check the air cleaner element for excessive dirt. ...

Other materials:

Dtc c1741 pressure sensor
DTC DETECTING CONDITION:• A fault is detected if two fluid pressure signals in master cylinder are out of normal range.• A fault is detected if the condition that supply voltage for the fluid pressure sensor is out of normal judgment range continues for predetermined time.• A fault ...