Subaru Legacy BN/BS (2015-2019) Service Manual: Removal
1. Disconnect the ground terminal from battery sensor. NOTE 2. Remove the clip (A), and loosen the clamps (B) and (C) securing the air intake boot.
3. Remove the air intake boot from the air cleaner case (rear) and throttle body, and move it to the left side wheel apron.
4. Disconnect the connector (A) from the starter, and remove the terminal (B).
5. Remove the bolts or nuts securing the starter, and remove the starter from the transmission. NOTE: For the MT model, a bolt is used at (a).
|
Starter
...
Assembly
1. Apply grease to the shaft sliding surfaces of the internal gear assembly.Grease:Multemp #6129 or equivalent2. Assemble the shaft to the internal gear assembly.3. Assemble the overrunning clutch as ...
Other materials:
Installation
1. CAM SPROCKET RH• Intake cam sprocket RH1. Install the intake cam sprocket RH by aligning the knock hole (A) of intake cam sprocket RH and the knock pin (B) of intake camshaft RH.NOTE:Before installation, check that there is no foreign matter on the intake cam sprocket RH and intake camshaft ...
