Subaru Legacy BN/BS (2015-2019) Service Manual: Removal
1. Remove the collector cover. (1) Carefully pull up the rear of collector cover at two positions (A). (2) Carefully pull up the front of collector cover at two positions (B) while moving it forward.
2. Disconnect the ground terminal from battery sensor. NOTE 3. Remove the V-belts. V-belt > REMOVAL 4. Disconnect the connector (A) from the generator, and remove the terminal (B). 5. Remove the harness cover (C) from the collector cover bracket. 6. Remove the collector cover bracket.
7. Remove the tensioner assembly.
8. Remove the generator from the A/C compressor bracket.
9. Remove the generator bracket from the engine.
|
Generator
...
Assembly
NOTE:After assembling, manually turn the pulley to check that the rotor rotates smoothly.1. Use the following procedures to install the rectifier.(1) Remove old silicone grease on the mating surface o ...
Other materials:
Dtc b1803 short in driver's airbag (to +b)
DIAGNOSIS START CONDITION:Ignition voltage is 10 V to 16 V.DTC DETECTING CONDITION:Short circuit failure in power supply (shorted in main harness power supply, shorted in roll connector power supply, shorted in driver’s airbag power supply, shorted in airbag CM internal circuit power supply)CA ...
