1. Disconnect the ground terminal from battery sensor. NOTE 2. Remove the rear wheel LH. Tire and Wheel > REMOVAL 3. Lift up the vehicle. 4. Remove the rear mud guard LH. Mud Guard > REMOVAL 5. Disconnect the quick connectors of the vent tube (A), canister drain tube (B) and purge tube (C), and remove the tubes from tube clamp (D). NOTE: Disconnect the quick connector as shown in the figure. • Vent tube (A) and canister drain tube (B) (Slider color is red or green.)
• Vent tube (A) and canister drain tube (B) (Slider color is white.)
• Purge tube (C)
6. Disconnect the connector (A) from the canister and remove the harness clip (B). 7. Remove the canister. 8. Remove the canister protector. 9. Disconnect the vent tube (A), canister drain tube (B) and purge tube (C). NOTE: Disconnect the quick connector as shown in the figure. • Vent tube (A) and canister drain tube (B) (Slider color is red or green.)
• Vent tube (A) and canister drain tube (B) (Slider color is white.)
• Purge tube (C)
10. Remove the hose clamp (D). 11. Disconnect the drain tube (A). NOTE: Disconnect the quick connector as shown in the figure. 12. Remove the leak check valve assembly from the canister. |
Preparation tool
1. SPECIAL TOOLILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS — (Newly adopted tool)SUBARU SELECT MONITOR 4Used for setting of each function and troubleshooting for electrical system.NOTE:For detailed operation procedures of Subaru Select Monitor 4, refer to “Application help”.99099AJ000ENG ...