Subaru Legacy BN/BS (2015-2019) Service Manual: Removal
1. Disconnect the ground terminal from battery sensor. NOTE 2. Remove the cover assembly - column. (1) Remove the clips, and remove the cover - column. (2) Remove the screws by turning the steering wheel to right and left. (3) Release the claw, and remove the cover assembly - column UPR and the cover assembly - column LWR.
3. Remove the switch assembly - combination wiper select. (1) Disconnect the connector. (2) Release the claws, and pull out the switch assembly - combination wiper select. CAUTION: Do not press the claws with excessive force. They may be damaged.
|
Inspection
1. INSPECTION OF SWITCH UNIT1. Operate the switches to check the continuity between terminals.Preparation tool:Circuit testerSwitch positionTerminal No.StandardOFFA1 and A3Less than 1 -INTA1 and A3Les ...
Other materials:
Dtc p0116 engine coolant temperature sensor 1 circuit range/performance
DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.TROUBLE SYMPTOM:• Hard to start• Improper idling• Poor driving performanceCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspectio ...
