Subaru Legacy BN/BS (2015-2019) Service Manual: Removal
1. Disconnect the ground terminal from battery sensor. NOTE 2. Remove the arm assembly - windshield wiper. Front Wiper Arm > REMOVAL 3. Remove the cowl panel - side and the cowl panel assembly. Cowl Panel > REMOVAL CAUTION: Before removing the cowl panel, use an air blower and nylon brush to sweep gravel from the lower area of the front side of the glass. 4. Disconnect the hose - windshield washer. • Models without EyeSight
• Models with EyeSight
5. Remove the nozzle - windshield washer. (1) Push the claw using a flat tip screwdriver, etc. (2) When the nozzle - windshield washer lifts up, pull out the nozzle - windshield washer using a clip remover, etc. (3) Disconnect the hose - windshield washer, and remove the nozzle - windshield washer.
|
Adjustment
1. NOZZLE - WINDSHIELD WASHER1. Turn the wiper switch to OFF position.2. While the vehicle is at a standstill, insert the washer nozzle adjustment tool (a) into upper side (b) and lower side (c) of th ...
Other materials:
Dtc b28b7 ldp off switch
Detected when lane departure warning OFF switch circuit is not installed, open-circuited, or is stuck to ON.DTC DETECTING CONDITION:• Wiring of lane departure warning OFF switch is not connected.• Lane departure warning OFF switch circuit is open.• Lane departure warning OFF switch ...
