Subaru Legacy BN/BS (2015-2019) Service Manual: Removal
1. WASHER TANK 1. Disconnect the ground terminal from battery sensor. NOTE 2. Remove the bumper face - front. Front Bumper > REMOVAL 3. Remove the tank - washer assembly. (1) Press the claw and remove the clip of the holder - windshield washer tank.
(2) Disconnect the connector from the motor pump assembly - washer and the sensor - washer tank, and then remove the harness clip. (3) Prepare a container before disconnecting the hose - washer, and drain all washer fluid in the tank - washer. (4) Remove the bolt and nuts and remove the tank - washer assembly.
2. WASHER MOTOR AND HOSE 1. Disconnect the ground terminal from battery sensor. NOTE 2. Remove the clips, and turn over the mud guard - front LH.
3. Disconnect the connector from the motor pump assembly - washer and remove the harness clip. 4. Prepare a container before disconnecting the hose - washer, and drain all washer fluid in the tank - washer. 5. Remove the motor pump assembly - washer.
6. Replace the washer hose if necessary. 3. WASHER FLUID LEVEL SENSOR 1. Disconnect the ground terminal from battery sensor. NOTE 2. Remove the clips, and turn over the mud guard - front LH.
3. Disconnect the connector from the sensor - washer tank, and remove the harness clip. 4. Prepare a container before disconnecting the hose - washer, and drain all washer fluid in the tank - washer. 5. Push the section (a) in the direction of the arrow with a thick towel or the like to remove the sensor - washer tank. CAUTION: Do not hit or apply any impact to the sensor - washer tank, because it has a poor resistance to impact. Sensor internal parts may be damaged when an impact is applied.
|
Inspection
1. WASHER PUMPApply battery voltage to the connector terminal of the motor pump assembly - washer, and make sure that the motor operates.2. WASHER FLUID LEVEL SENSOR1. Check the connection status of w ...
Other materials:
Parking tips
When parking your vehicle, always perform
the following items.
Apply the parking brake.
For MT models, place the shift lever in
the "1" (1st) for upgrade or "R" (Reverse)
for a downgrade.
For CVT models, place the select lever
in the "P" (Park) position.
Never rel ...
