Subaru Legacy BN/BS (2015-2019) Service Manual: Removal

Subaru Legacy BN/BS (2015-2019) Service Manual / Glass windows mirrors / Front regulator and motor assembly / Removal

1. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. NOTE

2. Remove the trim panel - front door. Door Trim > REMOVAL

3. Remove the sealing cover - front door. Front Sealing Cover > REMOVAL

4. Remove the glass assembly - front door. Front Door Glass > REMOVAL

5. Remove the regulator and motor assembly - front.

(1) Disconnect the motor - front connector.

(2) Remove the bolts, and then remove the regulator and motor assembly - front.

Front regulator and motor assembly

...

Inspection

1. Check the motor operation when battery voltage is applied between the connector terminals.• LH sideTerminal No.Inspection conditionsStandard6 (+) — 3 (−)Apply battery voltage between ...

Other materials:

Dtc p2404 evap system leak detection pump sense circuit range/performance
DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.WIRING DIAGRAM:• Engine Electrical System ENGINE T ...