Subaru Legacy BN/BS (2015-2019) Service Manual: Removal
1. Disconnect the ground terminal from battery sensor. NOTE 2. Remove the trim panel - rear door. Door Trim > REMOVAL 3. Remove the sealing cover - rear door. Rear Sealing Cover > REMOVAL 4. Connect the ground terminal to battery sensor. NOTE 5. Remove the glass assembly - rear door. (1) Install the switch - power window and then turn the ignition switch to ON. (2) Operate the switch - power window sub rear to move the glass assembly - rear door to the lowest position. (3) Remove the running channel - rear door. (4) Remove the screws and bolts, and then remove the sash assembly - rear partition.
(5) Remove the glass - rear door partition.
(6) While tilting the glass assembly - rear door, remove the guide from the roller of the regulator and motor assembly - rear, then remove the glass assembly - rear door. CAUTION: Avoid impact and damage to the glass assembly - rear door.
|
Rear door glass
...
Installation
1. Install the running channel - rear door to the panel assembly - rear door.CAUTION:Check that the running channel - rear door is securely fixed to the panel assembly - rear door and to the sash asse ...
Other materials:
Dtc u0075 control module communication bus "pu-can" off
DTC DETECTING CONDITION:Integrated unit communication is shut down because of high speed CAN error.TROUBLE SYMPTOM:CAN communication is not normal.STEPCHECKYESNO1.CHECK PERFORMING OF BASIC DIAGNOSTIC PROCEDURE.Was the basic diagnostic procedure performed up to STEP 8- Diagnostic Procedure with Diagn ...
