Subaru Legacy Service Manual: Removal
1. Disconnect the ground terminal from battery sensor. NOTE 2. Remove the roof spoiler. Roof Spoiler > REMOVAL 3. Remove the trim panel - rear gate and the motor assembly - rear wiper. Rear Wiper Motor > REMOVAL 4. Disconnect the rear defogger connector. 5. Remove the touch sensor LWR. (Model with power rear gate) Power Rear Gate Touch Sensor > REMOVAL 6. Remove the glass - rear gate in the same procedure as for the glass - front window. Windshield Glass > REMOVAL |
Rear gate glass
...
Installation
NOTE:Use the markings on the glass to apply adhesive and primer, and to install the dam rubber - rear gate and the spacer - rear gate.(a)Locating pin - rear gate(d)Marking for dam rubber - rear gate a ...
Other materials:
Operation
1. REGISTRATION (COMM CHECK)CAUTION:Because it will go back to Factory mode when the signal is weak, that you do not press the i button more than 2 seconds during a communication check. If it had returned to Factory mode, carrying out the CommCheck again. Each mode state can be confirmed in the &ldq ...