Subaru Legacy BN/BS (2015-2019) Service Manual: Removal

• For model with EyeSight, always remove the glass - front window after the stereo camera is removed.

• For model with EyeSight, always use Subaru genuine windshield glass specially designed for EyeSight. (If the windshield glass other than the glass specially designed for EyeSight is used, the visibility of the camera is blocked or the distortion of the glass prevents the correct measurement of the object, resulting in the EyeSight abnormal operation.)

• For model with EyeSight, if the windshield glass is installed after removal or replaced, always perform the “Inspection” and “Adjustment and check” of the stereo camera.

Inspection: General Description > INSPECTION

Adjustment and check: Camera Adjustment, Inspection

• For model with EyeSight, if the damage is found in the glass repair prohibited area, always replace the glass. Damage in the prohibited area can affect the recognition of the stereo camera even if it is repaired, and thereby EyeSight function may not operate properly.

(1) Apply sufficient amount of soapy water to the adhesive part and insert the windshield glass knife.

(2) While holding the edges of the knife and the glass - front window at a right angle, move the windshield glass knife parallel to the edge of the glass - front window, and cut the adhesive along the surface and the edge of the glass - front window.

CAUTION:

(3) Disconnect the locating pin - front window, and remove the glass - front window.

NOTE:

• Do not tightly pull the piano wire against the glass - front window edge.

• Apply protective tape, etc, and be careful that the inner and outer components of the vehicle are not damaged.

• Do not cross piano wires. Otherwise they may be cut.

(1) Using a drill, make a hole in the adhesive part.

(2) Pass the piano wire through the hole, and pull the wire ends alternately to cut off the adhesive part and the locating pin - front window.

CAUTION: