CAUTION: Refer to “CAUTION” of “General Description” before handling the airbag system components. General Description > CAUTION 1. Remove the headrest assembly - front. 2. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. NOTE NOTE: For models with power seat, remove the slide rail installing bolt before disconnecting the ground terminal from the battery sensor. 3. Remove the slide rail assembly installing bolt. (1) Tilt the backrest assembly forward. (2) Press the bolt cover claw (a) to remove the bolt cover. (3) Remove the slide rail installing bolt. 4. Disconnect the connector under the front seat. • Seat belt warning light connector (driver’s seat) • Occupant detection system harness connector (passenger’s seat) Airbag Connector > PROCEDURE • Side airbag connector Airbag Connector > PROCEDURE • Seat cushion airbag connector Airbag Connector > PROCEDURE • Seat heater connector (model with seat heater) • Buckle switch RH connector (passenger’s seat) Airbag Connector > PROCEDURE 5. Take out the front seat from the vehicle. CAUTION: Be careful not to damage the body. |
Assembly
1. CYLINDER BLOCK1. Apply liquid gasket to the threaded portion of the main gallery plug, and install the main gallery plug to the cylinder block LH.NOTE:Before applying liquid gasket, degrease the thread holes of the cylinder block LH and main gallery plug.Liquid gasket:THREE BOND 1105 (Part No. 00 ...