Spark plug: Refer to “SPECIFICATION” for spark plug. General Description > SPECIFICATION 1. RH SIDE 1. Disconnect the ground terminal from battery sensor. NOTE 2. Remove the air cleaner element and the air cleaner case (rear). Air Cleaner Element > REMOVAL 3. Disconnect the connector from ignition coil. NOTE: While pressing the spring (a) shown in the figure, slide it in the direction of the arrow with a clip remover. 4. Remove the ignition coil. 5. Remove the spark plug with a spark plug socket. 2. LH SIDE 1. Remove the battery. Battery > REMOVAL 2. Disconnect the connector from ignition coil. NOTE: While pressing the spring (a) shown in the figure, slide it in the direction of the arrow with a clip remover. 3. Remove the ignition coil. 4. Remove the spark plug with a spark plug socket. |
Inspection
1. Measure the resistance between connector terminals.Preparation tool:Circuit testerTerminal No.Inspection conditionsStandard3 — 9CANCELSET/−RES/+All OFFApprox. 4,020 -CANCELONLess than 1 -SET/−ONApprox. 250 -RES/+ONApprox. 1,470 -4 — 9CRUISE(MAIN)OFF1 M- or moreONLess than 1 -2. Ap ...