Subaru Legacy BN/BS (2015-2019) Service Manual: Replacement

Subaru Legacy BN/BS (2015-2019) Service Manual / Continuously variable transmission(tr580) / Extension case oil seal / Replacement

CAUTION:

Immediately after the vehicle has been running or after idling for a long time, the CVTF will be hot. Be careful not to burn yourself.

1. Lift up the vehicle.

2. Remove the center exhaust pipe. Center Exhaust Pipe > REMOVAL

3. Remove the center exhaust cover.

4. Clean the transmission exterior.

5. Remove the propeller shaft. Propeller Shaft > REMOVAL

6. Using a screwdriver or ST, remove the oil seal trying not to damage the extension case.

ST 398527700

PULLER ASSY

7. Using the ST, install the oil seal.

NOTE:

• Use a new oil seal.

• Apply CVTF to the oil seal lip and press-fitting surface.

ST 498057300

INSTALLER

8. Install the propeller shaft. Propeller Shaft > INSTALLATION

9. Install the center exhaust cover.

Tightening torque:

18 N·m (1.8 kgf-m, 13.3 ft-lb)

10. Install the center exhaust pipe. Center Exhaust Pipe > INSTALLATION

11. Adjust the CVTF level and check there is no leakage. CVTF > ADJUSTMENT

Inspection

Check for leakage of CVTF from the joint section of transmission and propeller shaft. If a leak is found, inspect the propeller shaft and replace the oil seal. ...

Other materials:

Bluetooth settings
WARNING Be sure to park the vehicle in a safe location before connecting or operating a Bluetooth phone or audio device. Failure to do so may result in loss of control of your vehicle and cause an accident or serious injury. Regulatory information The Bluetooth wo ...