CAUTION: Immediately after the vehicle has been running or after idling for a long time, the differential gear oil will be hot. Be careful not to burn yourself. 1. Lift up the vehicle. 2. Remove the front exhaust pipe. Front Exhaust Pipe > REMOVAL 3. Remove the center exhaust cover. 4. Clean the transmission exterior. 5. Remove the propeller shaft. Propeller Shaft > REMOVAL 6. Using a screwdriver or ST, remove the oil seal trying not to damage the extension case.
7. Using the ST, install the oil seal. NOTE: • Use a new oil seal. • Apply CVTF to the oil seal lip and press-fitting surface. Use a new oil seal.
8. Install the propeller shaft. Propeller Shaft > INSTALLATION 9. Install the center exhaust cover. Tightening torque: 18 N·m (1.8 kgf-m, 13.3 ft-lb) 10. Install the front exhaust pipe. Front Exhaust Pipe > INSTALLATION 11. Adjust the CVTF level and check there is no leakage. CVTF > ADJUSTMENT |
Installation
1. Install the O-ring to front reduction drive gear.NOTE:• Use new O-rings.• Apply CVTF to the O-rings.2. While holding the torque converter assembly by hand, carefully install it into the torque converter case.NOTE:• Apply CVTF to the oil seal lip.• Do not damage the oil sea ...