Subaru Legacy BN/BS (2015-2019) Service Manual: Replacement
1. Pull out the oil level gauge. 2. Lift up the vehicle. 3. Using the TORX® bit T70, remove the drain plug, and drain the transmission gear oil completely. CAUTION: • Immediately after the vehicle has been running or after idling for a long time, the gear oil will be hot. Be careful not to receive burns. • Be careful not to spill the gear oil on the exhaust pipe, to prevent emission of smoke or causing a fire. If gear oil is spilt, wipe it off completely. 4. Attach the drain plug using TORX® bit T70. NOTE: • Install the drain plug after draining transmission gear oil. • Use a new gasket. Tightening torque: 44 N·m (4.5 kgf-m, 32.5 ft-lb) (aluminum gasket, silver) 70 N·m (7.1 kgf-m, 51.6 ft-lb) (copper gasket, brown) 70 N·m (7.1 kgf-m, 51.6 ft-lb) (metal gasket, black)
5. Lower the vehicle. 6. Fill with transmission gear oil through the oil level gauge hole. CAUTION: If an alternative gear oil is used, you may not have expected functionality and performance. Recommended gear oil: SUBARU GEAR OIL EXTRA MT Alternative: GL-5 (75W-90) Gear oil capacity: 3.3 L (3.5 US qt, 2.9 Imp qt) 7. Check the transmission gear oil amount, and confirm that it is within the specification. |
Inspection
1. Park the vehicle on a level surface.2. Turn the ignition switch to OFF, and wait until the engine cools.3. Remove the oil level gauge and wipe it clean.4. Reinsert the oil level gauge all the way. ...
Other materials:
Disassembly
1. Remove the snap ring, and then remove the retaining plate, drive plate and driven plate.(A)Snap ring2. Compress the return spring using the ST to remove the snap ring.ST 18762AA001COMPRESSOR SPECIAL TOOL(A)Snap ring(B)Transfer clutch piston seal3. Remove the transfer clutch piston seal.4. Remo ...
