Subaru Legacy BN/BS (2015-2019) Owners Manual: Shifting speeds

Subaru Legacy BN/BS (2015-2019) Owners Manual / Starting and operating / Manual transmission / Shifting speeds

Recommended shifting speeds

The best compromise between fuel economy and vehicle performance during normal driving is ensured by shifting up at the speeds listed in the following table.

Recommended shifting speeds

Maximum allowable speeds

WARNING When shifting down a gear, ensure that the vehicle is not travelling at a speed exceeding the Maximum Allowable Speed for the gear which is about to be selected. Failure to observe this precaution can lead to engine over-revving and this in turn can result in engine damage.

In addition, sudden application of engine brakes when the vehicle is travelling on a slippery surface can lead to wheel locking; as a consequence, control of the vehicle may be lost and the risk of an accident increased.

The following table shows the maximum speeds that are possible with each different gear. The tachometer's needle will enter the red area if these speeds are exceeded.

With the exception of cases where sudden acceleration is required, the vehicle should not be driven with the tachometer's needle inside the red area. Failure to observe this precaution can lead to excessive engine wear and poor fuel economy.

Maximum allowable speeds

NOTE Never exceed posted speed limits.

Selecting reverse gear

CAUTION Shift into reverse ONLY when the vehicle has completely stopped. It may cause damage to the transmission to try shifting into reverse when the vehicle is moving. ...

Driving tips

NOTE If the accelerator and brake pedals are depressed at the same time, driving torque may be restrained. This is not a malfunction. Do not drive with your foot resting on the clutch pedal and ...

Other materials:

Disassembly
1. Flatten the tab of the lock nut.2. Using ST1, ST2 and ST3, fix at the spline portion of drive pinion shaft to remove the lock nut.ST1 499787500ADAPTERST2 499787700WRENCHST3 498937110HOLDER3. Remove the drive pinion shaft from the drive pinion retainer.4. Using the round bar with diameter ...