Subaru Legacy BN/BS (2015-2019) Service Manual: Specification

Subaru Legacy BN/BS (2015-2019) Service Manual / Lubrication(h6do) / General description / Specification

Lubrication method					Forced lubrication
Oil pump	Pump type				Trochoid type
	Number of teeth	Inner rotor			7
		Outer rotor			8
	Outer rotor diameter - Thickness			mm (in)	76 - 30.2 (2.99 - 1.19)
	Performance (Oil temperature 80°C (176°F))	600 r/min	Discharge pressure	kPa (kg/cm2, psi)	98 (1.0, 14)
			Discharge rate	L (US qt, Imp qt)/min	5.0 (5.3, 4.4) or more
		6,000 r/min	Discharge pressure	kPa (kg/cm2, psi)	392 (4.0, 57)
			Discharge rate	L (US qt, Imp qt)/min	82.8 (87.5, 72.9) or more
Oil filter	Filter type				Full-flow filter type
	Filtration area			cm2 (sq in)	1,300 (201.5)
	By-pass valve opening pressure			kPa (kg/cm2, psi)	160 (1.63, 23.2)
	Outer diameter - Width			mm (in)	80 - 75 (3.15 - 2.95)
	Installation screw specifications				M 20 - 1.5
Oil pressure switch	Type				Immersed contact point type
	Operating voltage — power consumption				12 V — 3.4 W or less
	Warning light operating pressure			kPa (kg/cm2, psi)	14.7 (0.15, 2.1)
	Proof pressure			kPa (kg/cm2, psi)	980 (10.0, 142)
Engine oil	Total capacity (at overhaul)			L (US qt, Imp qt)	7.8 (8.2, 6.9)
	When replacing engine oil and oil filter			L (US qt, Imp qt)	6.5 (6.9, 5.7)
	When replacing engine oil only			L (US qt, Imp qt)	6.3 (6.7, 5.5)

Recommended oil:

CAUTION:

It is acceptable to fill an engine with oil of another brand when replacing the oil, but make sure to use the following engine oil specified by Subaru.

Engine oil standard	Those with SN “Resource Conserving” logo in case of API standard.	or	Those with GF-5 “starburst mark” displayed on top of the container in case of ILSAC standard.
SAE viscosity No.

NOTE:

The proper viscosity oil helps the engine maintain its ideal temperature, and cranking speed increased by reducing viscosity friction in hot condition.

Caution

• Prior to starting work, pay special attention to the following:1. Always wear work clothes, a work cap, and protective shoes. Additionally, wear a helmet, protective goggles, etc. if necessary ...

Other materials:

Dtc p0966 pressure control solenoid "b" control circuit low
DTC DETECTING CONDITION:Immediately at fault recognitionTROUBLE SYMPTOM:Excessive shift shock1. ENGINE TYPE FBWIRING DIAGRAM:CVT control system CVT Control System > WIRING DIAGRAMSTEPCHECKYESNO1.CHECK INPUT SIGNAL FOR TCM.1) After driving with warm up condition, park the vehicle while depressing th ...