1. CONDITIONS FOR COMPLETION OF VDC SEQUENCE CONTROL When the following conditions develop, the VDC sequence control stops and VDC operation is returned to the normal control mode. • When the speed of at least one wheel reaches 10 km/h (6.2 MPH). • After completion of VDC sequence control. • When a malfunction is detected. |
Installation
1. Clean the mating surface of the extension case and intermediate case.2. Select the thrust needle bearing. Rear Drive Shaft > ADJUSTMENT3. Select the shim for transfer reduction driven gear. Transfer Reduction Driven Gear > ADJUSTMENT4. Install the selected thrust needle bearing to transfer clut ...