Subaru Legacy BN/BS (2015-2019) Owners Manual: Stopping engine

Subaru Legacy BN/BS (2015-2019) Owners Manual / Starting and operating / Starting and stopping engine (models with push-button start system) / Stopping engine

Stop the vehicle completely.
Move the select lever to the "P" position.
Press the push-button ignition switch.
The engine will stop, and the power will be switched off

WARNING

Do not touch the push-button ignition switch during driving.
When the push-button ignition switch is operated as follows, the engine will stop.

The switch is pressed and held for 3 seconds or longer.
The switch is pressed briefly 3 times or more in succession.
When the engine stops, the brake booster will not function. A greater foot pressure will be required on the brake pedal.
The power steering system will not operate either. A greater force will be required to steer, and it may result in an accident.

If the engine stops during driving, do not operate the push-button ignition switch or open any of the doors until the vehicle is stopped in a safe location. It is dangerous because the steering lock may be activated. Stop the vehicle in a safe place, and contact a SUBARU dealer immediately.

CAUTION

Do not stop the engine while the select lever is in a position other than the "P" position.
If the engine is stopped while the select lever is in a position other than the "P" position, the power will be in "ACC". If the vehicle is left in this condition, the battery may be discharged.

NOTE Although you can stop the engine by operating the push-button ignition switch, do not stop the engine during driving except in an emergency

When access key does not operate properly

Refer to "Access key - if access key does not operate properly" .

Starting engine

WARNING There are some general precautions when starting the engine. Carefully read the precautions described in "General precautions when starting/stopping engine" ...

Steering lock

After stopping the engine and the driver's door is open, the steering wheel will be locked due to the steering lock function. When the engine is restarted, the steering lock will be automaticall ...

Other materials:

Specification
ItemSpecificationTypeElectric typeClearance adjustmentAutomatic adjustingOperation methodSwitch type ...