Subaru Legacy BN/BS (2015-2019) Service Manual: Switches and harness

Installation

1. Install the 1st-2nd fork rod to the 1st-2nd shifter fork through the hole on the rear of the transmission case.2. Align the holes on the 1st-2nd fork rod and 1st-2nd shifter fork, and drive the str ...

Removal

1. BACK-UP LIGHT AND NEUTRAL POSITION SWITCH1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the clip (A) from the air intake boot.3. Loosen the clamp (B) connecting the air intak ...

Other materials:

Inspection
1. CHECK SWITCH UNITMeasure the resistance between connector terminals of the X mode switch. Terminal No.StandardOFF (when measured without operating the switch)No. 1 — No. 41 M- or moreON (when measured with the switch held down)Less than 1 -2. CHECK X MODE SYSTEMRefer to “CVT (TR580)&rdquo ...