Honda Civic manuals

Subaru Legacy BN/BS (2015-2019) Owners Manual: Switching power status

Switching power status

1) Operation indicator
2) Push-button ignition switch

The power status is switched every time the push-button ignition switch is pressed.

  1.  Carry the access key, and sit in the driver's seat.
  2.  Shift the select lever into the "P" position.
  3.  Press the push-button ignition switch without depressing the brake pedal. Every time the button is pressed, the power is switched in the sequence of "OFF", "ACC", "ON" and "OFF". When the engine is stopped and the push-button ignition switch is in "ACC" or "ON", the operation indicator on the push-button ignition switch illuminates in orange.

Power status

Indicator color

Operation

OFF Turned off Power is turned off.
ACC Orange The following systems can be used: audio and accessory power outlet.
ON Orange (while engine is stopped) All electrical systems can be  used.
Turned off (while engine is running)

 

CAUTION
  •  To prevent the vehicle battery from discharging, do not leave the push-button ignition switch in the "ON" or "ACC" position for a long time.
  •  To avoid a malfunction, observe the following precautions.
  •  Do not spill drinks or other liquids on the push-button ignition switch.
  •  Do not touch the push-button ignition switch with a hand that is soiled with oil or other contaminants.
  •  If the push-button ignition switch does not operate smoothly, stop the operation. Contact a SUBARU dealer immediately.
  •  If the push-button ignition switch does not illuminate even when the instrument panel illumination is turned on, have the vehicle inspected at a SUBARU dealer.
  •  If the vehicle was left in the hot sun for a long time, the surface of the push-button ignition switch may get hot. Be careful not to burn yourself.

NOTE

  •  When operating the push-button ignition switch, firmly press it all the way.
  •  If the push-button ignition switch is pressed quickly, the power may not turn on or off.
  •  If the indicator light on the pushbutton ignition switch flashes in green when the push-button ignition switch is pressed, steering is locked. When this occurs, press the push-button ignition switch while turning the steering wheel left and right.

Battery drainage prevention function

When the push-button ignition switch is left in the "ACC" or "ON" position for approximately 1 hour, the push-button ignition switch will be automatically switched to "OFF" to prevent the battery from going dead. This function is activated when the select lever is in the "P" position

Operating range for push-button start system
Legacy  Antenna  Operating range Outback  Antenna  Operating range NOTE  If the access key is not detected within the operating range of the an ...

Hazard warning flasher
The hazard warning flasher is used to warn other drivers when you have to park your vehicle under emergency conditions. The hazard warning flasher works with the ignition switch in any posit ...

Other materials:

Dtc p0073 ambient air temperature sensor circuit "a" high
NOTE:For the diagnostic procedure, refer to DTC P0072. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P0072 AMBIENT AIR TEMPERATURE SENSOR CIRCUIT "A" LOW1. OUTLINE OF DIAGNOSISDetect the open or short circuit of ambient temperature sensor.Judge as NG if out of specification.2. COMPO ...

© 2017-2024 Copyright www.sulegacy.com