Honda Civic manuals

Subaru Legacy BN/BS (2015-2019) Owners Manual: Warning and indicator lights

Several of the warning and indicator lights illuminate momentarily and then go out when the ignition switch is initially turned to the "ON" position. This permits checking the operation of the bulbs.

Apply the parking brake and turn the ignition switch to the "ON" position. For the system check, the following lights illuminate and turn off after several seconds or after the engine has started:

: Seatbelt warning light (The seatbelt warning light turns off only when the driver fastens the seatbelt.)

: Front passenger's seatbelt warning light (The seatbelt warning light turns off only when the front seat passenger fastens the seatbelt.)

: SRS airbag system warning light

ON / : Front passenger's frontal airbag ON indicator light

/ : Front passenger's frontal airbag OFF indicator light

/ : CHECK ENGINE warning light/ Malfunction indicator light

: Charge warning light

: Oil pressure warning light

: AT OIL TEMP warning light (CVT models)

/ : ABS warning light

: Vehicle Dynamics Control warning light/Vehicle Dynamics Control operation indicator light

: Vehicle Dynamics Control OFF indicator light

/ : Brake system warning light

: Hill Holder indicator light

: All-Wheel Drive warning light (CVT models)

: Power steering warning light

: Low tire pressure warning light (U.S. spec. models)

: Low fuel warning light

: Hill descent control indicator (if equipped)

: Automatic headlight beam leveler warning light (if equipped)

If any lights fail to illuminate, it indicates a burned-out bulb or a malfunction of the corresponding system.

Consult your authorized SUBARU dealer for repair.

ECO gauge
U.S. spec. models  Except U.S. spec. models The ECO gauge shows the difference between the average rate of fuel consumption since the trip meter was last reset and the current rate o ...

Seatbelt warning light and chime
Your vehicle is equipped with a seatbelt warning device at the driver's and front passenger's seat, as required by current safety standards. With the ignition switch turned to the "ON" position ...

Other materials:

General diagnostic table inspection
1. ENGINENOTE:Malfunction of parts other than those listed is also possible. Engine Trouble in GeneralSymptomsFaulty parts1. Engine stalls during idling.1) Manifold absolute pressure sensor2) Mass air flow and intake air temperature sensor3) Ignition parts (*1)4) Engine coolant temperature sensor ( ...

© 2017-2024 Copyright www.sulegacy.com