Subaru Legacy BN/BS (2015-2019) Service Manual: Weather strip replacement
1. FLANGE 1. Remove the weather strip - body side flange while pulling the rubber. Be careful not to tear the rubber. 2. Replace the weather strip - trunk lid while pulling the rubber. Be careful not to tear the rubber. NOTE: While removing the weather strip - trunk lid, be careful not to allow adhesive to contact the trim panel - roof assembly and trim panel - trunk side.
2. DOOR 1. Remove the weather strip after removing the clip. Be careful not to tear the rubber. CAUTION: If the weather strip clip is removed with excessive force, the weather strip may be damaged. Be sure to use clip remover to remove.
|
Protector tape installation
(a)Panel ASSY - rear door end(c)4 mm+0 mm −4 mm (0.16 in+0 in −0.16 in)(e)Push the application tape end against the panel assembly - rear door end.(b)Push the application tape end against ...
Door sash tape
...
Other materials:
Dtc b1832 short in curtain airbag rh squib circuit (to ground)
DIAGNOSIS START CONDITION:Ignition voltage is 10 V to 16 V.DTC DETECTING CONDITION:GND short circuit failure (shorted to ground in main harness, shorted to ground in curtain airbag RH, shorted to ground in airbag CM internal circuit)CAUTION:Before performing diagnosis, refer to “CAUTION” ...
