NOTE While the power rear gate is temporarily deactivated, if it is struck by body parts or objects and sustains a strong impact, the temporary deactivation may be canceled. The purpose of this is to absorb the impact of the collision and it is not a malfunction. In this case, the rear gate will not open or close automatically. If the power rear gate senses a malfunction, an electronic chirp will sound and the rear gate will stop opening or closing. In order for the rear gate to open and close automatically, carry out the following operation. If the rear gate does not open and close automatically after carrying out this operation, we recommend that you have the vehicle checked at a SUBARU dealer. When the rear gate is closed
When the rear gate is stuck at the fully open position or does not fully close If the rear gate cannot be closed due to a dead battery, etc., while the rear gate is stopped midway, it can be closed by hand.
When the rear gate cannot be opened Perform the procedure described in "Rear gate (Outback) - if the rear gate cannot be opened" . |
Inspection
1. Remove the bulkhead harness connector from TCM. Transmission Control Module (TCM) > REMOVAL2. Set the ST between the TCM and bulkhead harness.ST 18460AA040CHECK BOARD3. Set the probe of oscilloscope to the check board connector.Terminals:No. 13 (+) — No. 26 (−)(A)+ probe(B)− pro ...