Subaru Legacy BN/BS (2015-2019) Owners Manual: Windshield wiper blade rubber
1) Support
- Grasp the locked end of the blade
rubber assembly and pull it firmly until the
stoppers on the rubber are free of the
support.
1) Metal spines
- If the new blade rubber is not provided
with two metal spines, remove the metal
spines from the old blade rubber and
install them in the new blade rubber.
- Align the claws of the support with the
grooves in the rubber and slide the blade
rubber assembly into the support until it
locks
1) Claw
2) Stopper
- Be sure to position the claws at the
end of the support between the stoppers
on the rubber as shown. If the rubber is
not retained properly, the wiper blade may
scratch the windshield.
|
NOTE
Do not lower the wiper arm while the
wiper blade assembly is removed.
Raise the wiper arm off the windshield.
First raise the driver's side wiper arm and
then raise the front pass ...
Raise the wiper arm off the rear
window
Turn the wiper blade assembly counterclockwise.
Pull the wiper blade assembly toward
you to remove it from the wiper arm.
...
Other materials:
Dtc b27a1 driver side external antenna open
DTC DETECTING CONDITION:When open circuit occurs in the harness between keyless access CM and driver’s side front door outer handle antenna.TROUBLE SYMPTOM:Keyless access system does not function.CAUTION:For replacement procedure of keyless access CM, refer to the “REGISTRATION MANUAL FO ...