Honda Civic manuals

Subaru Legacy Owners Manual: Hill descent control function

The hill descent control function will be in standby mode when the X-mode is activated and the vehicle speed is less than approximately 12 mph (20 km/h).

The function will operate when the vehicle speed is less than approximately 12 mph (20 km/h) and the accelerator ratio is less than approximately 10%.

The function will turn off when the vehicle speed is more than approximately 12 mph (20 km/h) and the accelerator pedal is depressed.

CAUTION The braking power of the hill descent control function may not be sufficient when strong braking power is needed (e.g., when towing a trailer (Outback)).

NOTE

  •  Even while the hill descent control function is operating, you can vary the vehicle speed by using the brake pedal or accelerator pedal.
  •  During braking by the hill descent control function, the hill descent control indicator will flash.
  •  The hill descent control function is operable regardless of the gradient of the road.
  •  The hill descent control function may be considered normal when the following conditions occur.
  •  An operating sound is heard briefly from the engine compartment while the hill descent control function is operating.
  •  The sensation of depressing the brake pedal is different, (harder than usual etc.) when the brake pedal is depressed during hill descent control function operation.

Hill descent control indicator

Hill descent control indicator

This indicator appears while the hill descent control function is in the standby mode. It flashes while the function is operating. It will disappear when the function is in the disabled mode. When this function is changed from operational to non-operational, it will disappear when the vehicle speed reaches more than approximately 18 mph (30 km/h).

To activate/deactivate the X-mode
X-mode switch X-mode indicator To activate: Press the X-mode switch. While the Xmode is activated, the X-mode indicator appears. To deactivate: Press the X-mode switch again. The Xmod ...

Tire pressure monitoring system (TPMS) (if equipped)
Low tire pressure warning light The tire pressure monitoring system provides the driver with a warning message by sending a signal from a sensor that is installed in each wheel when tire press ...

Other materials:

Dtc b2285 steering lock position signal correlation
DTC DETECTING CONDITION:When the steering lock position signal transmitted from the steering lock CM via solid line and the steering lock position signal transmitted via LIN communication system do not match.TROUBLE SYMPTOM:• There are conditions when the steering lock is not released.• ...

© 2017-2019 Copyright www.sulegacy.com