Subaru Legacy BN/BS (2015-2019) Service Manual: Assembly

Subaru Legacy BN/BS (2015-2019) Service Manual / Exhaust(h6do) / Front exhaust pipe / Assembly

1. Install each cover to the front exhaust pipe.

Tightening torque:

13 N·m (1.3 kgf-m, 9.6 ft-lb)

2. Install the front oxygen (A/F) sensor and rear oxygen sensor. Front Oxygen (A/F) Sensor > INSTALLATION Rear Oxygen Sensor > INSTALLATION

3. Install the front exhaust pipe (RH) to the front exhaust pipe (LH).

NOTE:

Use a new gasket.

Tightening torque:

30 N·m (3.1 kgf-m, 22.1 ft-lb)

Removal

CAUTION:Vehicle components are extremely hot after driving. Be wary of receiving burns from heated parts.1. Disconnect the ground terminal from battery sensor. NOTE2. Lift up the vehicle.3. Remove th ...

Installation

1. Install the front exhaust pipe assembly.NOTE:Use a new gasket.2. Temporarily tighten the nuts which hold front exhaust pipe assembly to cylinder heads.3. Install the bolts, springs and nuts securin ...

Other materials:

Inspection
CAUTION:Because the center pilot bearing is grease-sealed and is a non-lubrication type, do not wash with gasoline or solvents.1. If there is damage or defectiveness in the facing sliding surface or ring gear, replace the flywheel.(A)Flywheel(B)Ring gear2. Smoothness of rotationRotate the ball beari ...