Subaru Legacy BN/BS (2015-2019) Service Manual: Caution
• Before disconnecting connectors of sensors or units, be sure to disconnect the ground cable from battery. When replacing the electrical parts provided with memory functions that store contents specified by a customer, record the memory contents before disconnecting the battery ground cable. • Be careful of the following items. Failing to do so may cause the airbag system malfunction. – Yellow connectors and harnesses with yellow tapes around them are the connectors and harnesses for the airbag system. When using a tester on these circuits, follow the cautions of “AIRBAG SYSTEM”. General Description > CAUTION – Be careful not to damage the airbag system wiring harness when servicing the electrical parts around the steering column. • When removing, installing or replacing the VDCCM&H/U, VDCCM&H/U bracket, steering wheel or steering angle sensor (steering roll connector), perform “VDC sensor midpoint setting mode” of the VDC. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) > ADJUSTMENT |
Preparation tool
TOOL NAMEREMARKSCircuit testerUsed for measuring resistance, voltage and current. ...
Location
Refer to “LOCATION” of “CRUISE CONTROL SYSTEM (DIAGNOSTICS)” section. Electrical Component Location > LOCATION ...
Other materials:
Removal
1. Open the trunk lid COMPL.2. Disconnect the ground terminal from battery sensor. NOTE3. Remove the trim panel - trunk lid. Trunk Room Trim > REMOVAL4. Remove the lock assembly - trunk lid.(1) Disconnect the connector.(2) Remove the bolts, then remove the lock assembly - trunk lid. ...
