Subaru Legacy BN/BS (2015-2019) Service Manual: Caution
1. SRS AIRBAG SYSTEM Airbag system wiring harness is routed near the TPM control module. CAUTION: • Do not use electrical test equipment on any of the airbag system wiring harness circuits. • Be careful not to damage the wiring harness of the airbag system, when servicing the TPMS & keyless entry CM or TPMS CM. 2. TPMS & KEYLESS ENTRY CM OR TPMS CM • If the transmitter is replaced, ID registration for the transmitter is required. Register Transmitter (ID) > OPERATION • When adjusting tire pressure indoors in winter, there is a big temperature difference between the indoor facilities and outside. Once the car is outside where the temperature is lower, the air pressure in the tires will drop, causing the tire pressure warning light to illuminate, even if the pressure in the tires was adjusted to standard values indoors. To avoid this, it is necessary to adjust the tire pressure to the high side in consideration of the difference in temperature between inside and outside according to the following table. • 225/60R18, 225/65R17
• 225/50R18, 225/55R17
| ||||||||||||||||||||||||||||||||||||
Preparation tool
1. SPECIAL TOOLILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS — (Newly adopted tool)SUBARU SELECT MONITOR 4Used for setting of each function and troubleshooting for electrical system.NOTE:For detailed op ...
Inspection
Before performing diagnosis, check the following item which might affect the quality of the tire pressure monitoring system.1. TIRE• Inspect that the tire pressure is within the specification wh ...
Other materials:
Installation
1. Install the cushion rubber and the heat shield cover to the vehicle body.Tightening torque:10 N·m (1.0 kgf-m, 7.4 ft-lb)2. Install the muffler to the cushion rubber.3. Install the bolts and self-locking nuts securing the rear exhaust pipe to the muffler.NOTE:• Use a new gasket and se ...
