Subaru Legacy BN/BS (2015-2019) Service Manual: Caution

Subaru Legacy BN/BS (2015-2019) Service Manual / Starting charging systems(h4do) / General description / Caution

• Prior to starting work, pay special attention to the following:

1. Always wear work clothes, a work cap, and protective shoes. Additionally, wear a helmet, protective goggles, etc. if necessary.

2. Protect the vehicle using a seat cover, fender cover, etc.

3. Prepare the service tools, clean cloth, containers to catch grease and oil, etc.

• Vehicle components are extremely hot immediately after driving. Be wary of receiving burns from heated parts.

• When performing a repair, identify the cause of trouble and avoid unnecessary removal, disassembly and replacement.

• Before disconnecting connectors of sensors or units, be sure to disconnect the ground cable from battery.

• Always use the jack-up point when the shop jacks or rigid racks are used to support the vehicle.

• Remove contamination including dirt and corrosion before removal, installation, disassembly or assembly.

• Keep the removed parts in order and protect them from dust and dirt.

• All removed parts, if to be reused, should be reinstalled in the original positions with attention to the correct directions, etc.

• Bolts, nuts and washers should be replaced with new parts as required.

• Be sure to tighten the fasteners including bolts and nuts to the specified torque.

Specification

ItemSpecificationsVehicle modelCVTMTStarterTypeReduction typeModelM000T38571ZCM000T33176ZCManufacturerMitsubishi ElectricVoltage and output12 V — 1.2 kW12 V — 1.0 kWDirection of rotationCounterclo ...

Preparation tool

1. GENERAL TOOLTOOL NAMEREMARKSCircuit testerUsed for measuring resistance, voltage and current.NOTE:• When measuring the standby current, prepare a circuit tester which can measure down to 1 mA ...

Other materials:

Dtc b14a5 refrigerant flow sensor circuit open
DTC DETECTING CONDITION:• The voltage of the refrigerant flow sensor signal line increased to 4.7 V or more.• Open circuit in refrigerant flow sensorTROUBLE SYMPTOM:A/C does not function because refrigerant flow amount cannot be measured.WIRING DIAGRAM:NOTE:For the coupling connector, re ...