Subaru Legacy BN/BS (2015-2019) Service Manual: Clear memory mode operation
1. On «Start» display, select «Diagnosis». 2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed». 3. On «Main Menu» display, select «Each System». 4. On «Select System» display, select «Subaru Rear Vehicle Detection(RH)» or «Subaru Rear Vehicle Detection(LH)» and then select «Enter». 5. On «Select Function» display, select «DTC». 6. On «DTC» display, select «Clear Memory». NOTE: For operation procedures, refer to “Application help”. |
Check list for interview check
• Inspect the following items regarding the vehicle’s state.• Print out this page for interviewing customers.Blind Spot Detection/Rear Cross Traffic Alert Check List for InterviewRec ...
Diagnostic procedure with cancel code dtc b2328 rear radar internal failure (radar misalignment)
DETECTING CONDITION:• Excessive impact was given to the installation area of the radar sensor, which resulted in deviation of the radar sensor axis.• Mounting bracket for the radar sensor ...
Other materials:
Removal
CAUTION:• Be sure to prevent water or oil from contacting the connector terminal of secondary pressure sensor. If adhesion occurs, replace with a new part.• When removing secondary pressure sensor, CVTF may let out. If CVTF has leaked, adjust the CVTF level after installing the secondary ...
