Subaru Legacy BN/BS (2015-2019) Service Manual: Disassembly
1. DIFFERENTIAL CASE ASSEMBLY 1. Loosen the twelve bolts and remove hypoid driven gear.
2. Drive out the straight pin from differential assembly toward hypoid driven gear side.
3. Pull out the pinion shaft, and remove the differential bevel pinion, differential bevel gear and adjusting washer.
4. Using the ST, remove the taper roller bearing.
2. DIFFERENTIAL SIDE RETAINER 1. Remove the O-rings.
2. Remove the oil seal. NOTE: Remove using the flat tip screwdriver.
|
Inspection
Repair or replace the differential gear in the following cases:• When the hypoid driven gear and drive pinion shaft tooth surfaces are damaged, excessively worn, or seized.• When the rolle ...
Assembly
1. DIFFERENTIAL CASE ASSEMBLY1. Install the differential bevel gear and differential bevel pinion together with adjusting washer, and insert the pinion shaft.NOTE:Face the chamfered side of adjusting ...
Other materials:
ABS warning light
CAUTION
If any of the following conditions
occur, we recommend that you
have the ABS repaired at the first
available opportunity by your
SUBARU dealer.
The warning light does not
illuminate when the ignition
switch is turned to the "ON"
...
