Subaru Legacy BN/BS (2015-2019) Service Manual: Dtc b2327 rear radar internal failure (internal electric circuit)

Subaru Legacy BN/BS (2015-2019) Service Manual / Blind spot detection rear cross traffic alert (diagnostics) / Diagnostic procedure with diagnostic trouble code (dtc) / Dtc b2327 rear radar internal failure (internal electric circuit)

DTC DETECTING CONDITION:

Defective radar sensor

TROUBLE SYMPTOM:

• All functions of BSD/RCTA stop.

• Fail icon is displayed in the combination meter LCD display.

• Failure-related notification is displayed for approx. two seconds on LCD display in the combination meter.

NOTE:

Check and replace the side that displayed the DTC.

STEP	CHECK	YES	NO
1.CHECK BSD/RCTA. 1) Perform the Clear Memory Mode. Clear Memory Mode 2) Read the DTC again. Read Diagnostic Trouble Code (DTC)	Is DTC B2327 displayed- (Current malfunction)	Replace the radar sensor. Radar Sensor	Even if DTC is displayed, the circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again. NOTE: In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.

Dtc b2329 rear radar axis alignment incomplete

DTC DETECTING CONDITION:Axis adjustment of the radar sensor has failed.(Forced termination of the Subaru Select Monitor, improper location of the target reflector, or deviation of the radar sensor due ...

Dtc b2313 rear radar detect vdc

DTC DETECTING CONDITION:Vehicle dynamics control (VDC) fails.TROUBLE SYMPTOM:• All functions of BSD/RCTA stop.• Fail icon is displayed in the combination meter LCD display.• Failure- ...

Other materials:

If the light is blinking
If the light is blinking while driving, an engine misfire condition has been detected which may damage the emission control system. To prevent serious damage to the emission control system, you should conform to the following instructions. Reduce vehicle speed. Avoid hard a ...