Subaru Legacy BN/BS (2015-2019) Service Manual: Dtc p0463 fuel level sensor "a" circuit high

Subaru Legacy BN/BS (2015-2019) Service Manual / Engine (diagnostics)(h4do) / Diagnostic procedure with diagnostic trouble code (dtc) / Dtc p0463 fuel level sensor "a" circuit high

DTC DETECTING CONDITION:

Detected when two consecutive driving cycles with fault occur.

CAUTION:

After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.

STEP	CHECK	YES	NO
1.CHECK FOR ANY OTHER DTC ON DISPLAY.	Is DTC P0462 or P0463 displayed on the Subaru Select Monitor-	Check the combination meter. Basic Diagnostic Procedure	Even if DTC is detected, the circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again. NOTE: In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.

1. OUTLINE OF DIAGNOSIS

Detect the open or short circuit of fuel level sensor. Judge as NG if out of specification.

2. COMPONENT DESCRIPTION

(1)	Engine control module (ECM)	(3)	Fuel level sensor	(5)	Body integrated unit
(2)	Fuel sub level sensor	(4)	Detecting circuit

3. EXECUTION CONDITION

Secondary Parameters	Execution condition
Battery voltage	≥ 10.9 V

4. GENERAL DRIVING CYCLE

Always perform the diagnosis continuously.

5. DIAGNOSTIC METHOD

If the duration of time while the following conditions are met is longer than the time indicated, judge as NG.

Judgment Value

Malfunction Criteria	Threshold Value
Output voltage	≥ 12 V

Time Needed for Diagnosis: 1000 ms

Malfunction Indicator Light Illumination: Illuminates when malfunction occurs in 2 continuous driving cycles.

Dtc p0500 vehicle speed sensor "a" circuit

DTC DETECTING CONDITION:Immediately at fault recognitionCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mod ...

Dtc p0462 fuel level sensor "a" circuit low

NOTE:For the diagnostic procedure, refer to DTC P0463. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P0463 FUEL LEVEL SENSOR "A" CIRCUIT HIGH1. OUTLINE OF DIAGNOSISDetect the open or ...

Other materials:

Removal
CAUTION:If the CVTF and engine coolant is spilt over exhaust pipe, wipe it off with cloth to avoid emitting smoke or causing a fire.1. Disconnect the ground terminal from battery sensor. NOTE2. Drain engine coolant. Engine Coolant > REPLACEMENT3. Remove the clip (A), and loosen the clamps (B) and ...