Subaru Legacy BN/BS (2015-2019) Service Manual: Dtc p160a random access memory (ram) error

Subaru Legacy BN/BS (2015-2019) Service Manual / Continuously variable transmission (diagnostics) / Diagnostic procedure with diagnostic trouble code (dtc) / Dtc p160a random access memory (ram) error

DTC DETECTING CONDITION:

Detected when two consecutive driving cycles with fault occur.

TROUBLE SYMPTOM:

TCM RAM malfunction

STEP	CHECK	YES	NO
1.CHECK DTC. 1) Perform the Clear Memory Mode using the Subaru Select Monitor. Clear Memory Mode 2) Read the DTC.	Is DTC P160A displayed-	Replace the TCM. Transmission Control Module (TCM) Transmission Control Module (TCM)	Current condition is normal. Check for interference from noise, etc.

1. OUTLINE OF DIAGNOSIS

• Judge the malfunction in RAM area of the TCM.

• Judge as NG if an attempt to write to RAM area failed.

2. EXECUTION CONDITION

Secondary Parameters	Execution condition
12 V battery system voltage	≥ 9 V

3. DIAGNOSTIC METHOD

If the duration of time while the following conditions are met is longer than the time indicated, judge as NG.

Judgment Value

Malfunction Criteria

Threshold Value

Writing-check (RAM)

NOTE:

This check is carried out about the RAM used except for CAN communication.

Error

Time Needed for Diagnosis: Immediately

Malfunction Indicator Light Illumination: Illuminates when malfunction occurs in 2 continuous driving cycles.

Dtc p2746 intermediate shaft speed sensor "b" circuit range/performance

DTC DETECTING CONDITION:Immediately at fault recognitionTROUBLE SYMPTOM:• Standing start problems• Shock occurs when engaging the lockup clutch.• Shock occurs when selecting shift po ...

Dtc p0977 shift solenoid "b" control circuit high

DTC DETECTING CONDITION:Immediately at fault recognitionTROUBLE SYMPTOM:Gear is not changed. (No down-shift)1. ENGINE TYPE FBWIRING DIAGRAM:CVT control system CVT Control System > WIRING DIAGRAMSTEPC ...

Other materials:

Installation
1. GLASS LID1. Install the lid assembly - sunroof.Tightening torque:4.5 N·m (0.5 kgf-m, 3.3 ft-lb)2. Perform the open/close operation checks for the glass lid.3. Check the height of the lid assembly - sunroof and the roof panel, and perform adjustment when there is a difference between up and ...